rmeekerwrx

MLV and CCF or* will just MLV do?!?!

I have searched around now for quite some time and can't really find anyone directly addressing my question so here it goes.

I am in the process of adding dynamat to my WRX (focusing on the doors, trunk and rear deck for now) I have already purchased the MLV I will be using, and was just wondering is it worth the money and time to add a layer of CCF (was thinking ensolite) first, then installing the MLV over that?

OR would the difference in deadening quality be so minimal that just using the dynmat and MLV would suffice?

Any and all opinions and advice would be greatly appreciated!!

Oh one last question! My MLV is not peel and stick, what are some recommended types of adhesive?

rmeekerwrx

Help bump!!!

danyman

iTrader: (1)

all it is really is to decouple the MLV for any surface. so yes the CCF is needed.. u can use any type of foam as long that its mold resistant

rmeekerwrx

Thank you very much for the response! With some more internet searching over the past few weeks I was able to find that the foam mainly is used for decoupling the MLV, so I went ahead and bought some peel and stick ensolite. Seems to work great, its a slow process though!! Only have one door finished at this point.

danyman

iTrader: (1)

i wish to get some stuff for my car too lol been trying for over a year now.. good luck let us now the difference. hope u do the floor too