95-98 Yukon/Tahoe, whos worked on one?
#1
#3
ok i have to rewire all of my mids/highs direct to the amp instead of running to the back of the dash and then to the amp
tweets and 6 1/2s in each of the front doors, and 6 1/1 coaxs in the rear doors and 4x10s in the rear roof
i need to know which panels and how to take each off that i need to remove, it looks like a real PITA and i dont want to take panels off that i dont have to and break something, which usually happens because im so impatient when it comes to removing door panels
either that, or could i jsut hook the new wire onto the old wire somehow and just pull it through and then run to the amp
any help would be appreicated
dc
tweets and 6 1/2s in each of the front doors, and 6 1/1 coaxs in the rear doors and 4x10s in the rear roof
i need to know which panels and how to take each off that i need to remove, it looks like a real PITA and i dont want to take panels off that i dont have to and break something, which usually happens because im so impatient when it comes to removing door panels
either that, or could i jsut hook the new wire onto the old wire somehow and just pull it through and then run to the amp
any help would be appreicated
dc
#4
i would look at each panel and go slow .if i do not need to remove someting i will not remove it .try running the wire at the foot sill
so if you come form the deck into the dash behind the kick panel under the foot sill slip under the rug (piller) under the next foot sill into the trunk/back remove back panel(side)
it is not hard but take your time
so if you come form the deck into the dash behind the kick panel under the foot sill slip under the rug (piller) under the next foot sill into the trunk/back remove back panel(side)
it is not hard but take your time
Thread
Thread Starter
Forum
Replies
Last Post
ZachCHartwell
Canadian General Car Audio Discussion
3
06-23-2003 05:18 PM