So, I'm going to need to totally decontaminate the boards, I'm going to make a wash and dry box , like a tabletop sand blast box(gloved)

So what do I use? I was thinking I would first spray them down with 99% ISO and q-tip any "bad" spots, when a rinse with distilled water.
Dry in box until its time to submerge them.

See any possible problems with that guys?

 

Did a mock up of the loose boards... The amps have a ground to chassis, and well, no chassis now, so I used a threaded rod to connect them together as a single ground.. I'll be changing it to a brass rod before completion..



I then noticed that the other holes didn't quite line up!!! I couldn't use the metal rod.. So I grabbed a plastic rod and machined it, tapped the boards with the same fine thread, and screwed them together..



Have to run ALOT of wires to the outside air, 4 awg grommets will work , keeping the oil in the rack.. I hope



The voltage meter and remote temp gauge. We'll attach that inside the rack in the oil ...

 

Where did you get that volt/temp/clock thingy? Is the temp sensor on a wire (aka remote)?

 

ebay..straight from china, took forever but was well priced...Hopfully it doesn't die too quick..lol yep wired

 

Hey soul, nice to see your going to take the advice. To make it really really cool, add a light and a little fish tank bubbler.

 

Yeah, man, I`ve got some fantastic advice and ideas from Kev and others... Gonna take alot longer , but it should be the best amp I`ve ever owned..
I`m not sure if I`ll use a bubbler or not, I have been giving thought to using a small pump and a simple aftermarket tranny cooler for a car.. Like this one maybe..

http://www.ebay.com/itm/12-Finned-Si...item1c197fc71a

I`m not even sure I`ll need more cooling then just the oil, the good part is I can still add it after without opening it. I can just leave a couple extra grommets unused just in case.

I`m not big on lights , I ussually disable any amp lights that are too bright.....lol