Bosbury1

Installed APS787Z today - Red Wire to constant 12V / Red/White wire to constant 12V, Blue to Ignition, and Yellow to Starter. Checked with test light at harness all wires getting power two constant and the one via the ignition. The issue is the Valet FOB no light goes on. However, the red with via the test light goes on. The instructions state turn key to the on position depress the key FOB valet button three times and the system will beep and flash. Nothing on my unit. Any thoughts? Frustrating. Also, my 1994 Jeep XJ has a type A door lock (positive) I wired up a relay to change to a negative trigger could my vehicle wiring chart be incorrect and they are actually negative triggers instead of a postiive trigger? Could this be the issue the valet key FOB does not work. Any suggestions would be much appreciated. Thank you.