Amplifier Problem
Thread Starter
0 Watt CAFz'r
Joined: Dec 2007
Posts: 11
Amplifier Problem
So I finally finished my speaker/sub/amp install tonight. BUt of course I have problems.
My amp is not getting nearly enough current. The voltage reads steady at 13.5, but the amperage/current reads ZERO.
If I crank the gains there is some movement in current but very little. The speakers and sub turn on and produce underpowered sound...my factory rear speakers pound much louder than my Alpine Type X components.
I'm using an Earthquake 900w.5 5 channel. The fuses seem fine. Using jumper cables i ran the ground to the battery and still nothing.
It also pics up engine feedback and other noise. RCA and power are on opposite sides.
Im using an Eclpise 4000 deck.
What did I do wrong?
My amp is not getting nearly enough current. The voltage reads steady at 13.5, but the amperage/current reads ZERO.
If I crank the gains there is some movement in current but very little. The speakers and sub turn on and produce underpowered sound...my factory rear speakers pound much louder than my Alpine Type X components.
I'm using an Earthquake 900w.5 5 channel. The fuses seem fine. Using jumper cables i ran the ground to the battery and still nothing.
It also pics up engine feedback and other noise. RCA and power are on opposite sides.
Im using an Eclpise 4000 deck.
What did I do wrong?
Last edited by robyo23; Feb 5, 2008 at 09:42 PM.
Thread
Thread Starter
Forum
Replies
Last Post
vip3r87
Car Audio Technical Discussions
6
Dec 3, 2006 07:17 PM
Keith
General SQ
74
Nov 24, 2003 05:48 PM
