Lspade69

iTrader: (2)

The suggested port length for a box that I am making is 25" long. It will be a square port (2.65" x 2.65") and I am planning on having a 90 degree bend around a corner. Will this affect anything such as what the box is tuned to? Thanks for the advice.

hofulstrof

just remember, to measure the length of a port you measure directly down the center, and youll be good to go

Lspade69

iTrader: (2)

oh, that makes a lot of sense. Thanks.

hofulstrof

i drew a picture anyway just because i was bored

Dukk

Why go to the trouble of building a square vent of the same area as 3" pipe??

Go get a 4' piece of 3" pipe and an elbow..

BigRedGuy

iTrader: (11)

You know, you've got to stop coming up with all these simple solutions to things......people are going to stop believing it's all done with magic.....

BTW, how's the hearse coming along? Any new pics?

Dukk

bleh. nothing new. I do however have the funds for the carburetor, carpet, and RCAs now and intend to get that on the go. Then I have to buy a lot of power cable..

Lspade69

iTrader: (2)

Haha, thanks for all the new info.

BigRedGuy

iTrader: (11)

Good to hear it's still progressing along....I can see a reel or two of 0/1 in your future.....

Looking forward to more pics.....

robmar

simple solution for that as well
batterys in the back and do what the old dragster boys did drive the alternator off the drive shaft
just put it on jack stands for db dragging
the fans will love it
a little propane or extra fuel out the tail pipe and do a flame job too
maybe some smoke
they won't see your numbers until the smoke clears