Playboy

Looking to build a ported box for a single DD 9512. I have a us amps MD3 powering it. Im using 1" mdf as i already have a full sheet laying around, i would like a slot port. Ive been looking for a program to input my measurments etc. and have a cut out sheet i can just use to cut it all...Im just not sure of a good program. i have Winisd but it doesnt help me much.

h = 14in
l = 30in
w = 25in

Tuned to 35hz

Thanks for any help.
Kyle.

Prolifik

iTrader: (7)

put it in a 2 cube box.

The A Team

iTrader: (1)

also works in a 1.7 cu/ft box tunned to 57 hz

MTA

iTrader: (1)

if those are internal measurements make the port 14x4.5 x 22.5 deep

if they are external make the port 12x3.25x23.5

either one should work pretty good

I use WINISD

Playboy

Thanks for the port dimensions...i used to have a web site where you can input your measurements, and it would calculate your box for you and would give you a colour template on what cuts you need to make and what sizes? this was for a vented box. Does anyone know what that site was? i lost it last time i formatted. Bassically im just unsure of how to cut the inside port walls and to what sizes thats all...if i decide to change the internal size of the box, bracing etc.

Thanks,
Kyle.

worldind

iTrader: (17)

Here it is... props to hofulstrof for the post.

Free Ported Subwoofer Plans brought to you by Subwoofertools.com Forum