matt_s

Hey, so I'm wondering does any one have any ideas of how to install my set up? I need a box for two 10's and an amp rack, I will have two amps, but only one at first. Any ideas? Here is my trunk

Right

Middle

Left

zzzzzzz

iTrader: (5)

fire the subs with the port up at the glass
can you post a pic of the amp sub and things you are adding

matt_s

I'm not sure what I'm going to have for a box, haven't built it yet. I'm just not two sure were i should mount my amps, any ideas?

zzzzzzz

iTrader: (5)

i would need to know the size of amp or a pic of what you are looking at

matt_s

I'm not 100% sure on what amp I'm I'm going to run, just that i need around 250watts RMS to each of my subs. I'm more or less just looking for suggestions on were to place this equipment, i DON'T care about space, it can take up the WHOLE trunk for all i care. How would you set it up in this trunk?

zzzzzzz

iTrader: (5)

if you get 2 amps 1 for the main and one for thr subs i would do the sidesof the car each side

if i have a bigger amp just for the subs i would place the amp on the floor and have the behind it

the box i would play with to see if it hits at wall of the trunk or if i set it up to hut the glass at 90* to the glass

zzzzzzz

iTrader: (5)

i think i would look at alpine type amps for the side

Dukk

Make or buy yourself a vented dual 10 box and mount your amp(s) on the back of it.

zzzzzzz

iTrader: (5)

that can be hard on an amp but the box i would go with if it was ok for the subs

CanadianBronco

If your worried about it being hard on amps, Cut some rubber hose in 1" lengths squish it and put it between the amp and box, then screw it in,

But its not like box vibrations are the only thing to your amps, anywhere you mount them road vibration will still get to it too