loketar

Hi Guys,
I have a question regarding my sub enclosure. I would just like to know if this setup is going to sound ok or not. I have a custom box that was built for a 1996 Chevy Silverado Ext. cab, to fit under the rear seat. It is a sealed box with the subs facing forward and was a steal off of used Victoria for $40. Now according to the sticker on the back from the builder it has 1.7ft.cu. I have ordered a pair of RE Audio REX10D4 to put in it. I am hoping I have read the specs correctly and the subs will sound ok in there. The specs for the subs are:

* 10" Dual 4 ohm REX Series Subwoofer
* Power Handling: o RMS: 175 watts
* Impedance: Dual 4 ohm
* Mica filled poly cone woofer
* Santoprene rubber surround
* Pressed steel basket
* FEA Optimized motor structure
* Linear Conex spiders
* Rubber gasket
* High temperature 8-layer copper voice coil
* Powerful, single stacked magnet
* Sensitivity: 84.7 dB
* Mounting Depth: 5"
* Authorized Internet Dealer
* 1-year Manufacturer's warranty

REX 10D4" T/S Parameters:

* Electrical Q Value (Qes): 0.39
* Mechanical Q Value (Qms): 4.37
* Total Speaker Q Value (Qts): 0.36
* Free Air Resonance (Fs): 21.5 Hz
* Equivalent Compliance (Vas): 75.6 liters
* One-Way, Linear Excursion (Xmax): 12 mm
* Efficiency (SPL 1W/1m): 84.7 dB SPL
* Effective Piston Area (Sd): 322 cm2
* DC Resistance (Re): 3.2 ohm
* Nominal Impedance (Znom): Dual 4 ohm
* Thermal Power Handling (Pe): 175 W
* Force Factor (Bl): 15.4
thanks in advance for your replys.
Cheers, Loke

loketar

hey anybody around these days?????

stephenfleming

iTrader: (1)

What size box do those subs need?

loketar

according to the RE web site max. is .05 each...

DeadlySones

iTrader: (4)

re specs are .5 cubes each and the subs displacement is .09 each. So, with two you are looking @ 1.18cuft. you would actually have enough room in that box for 2 12's sealed if they would fit/mount... or else maybe 3 10's.

If your set on two you might have a lil too much air space for sealed and need to remove some... or find room for a port out the side of the box....

loketar

hmmmmm,thanks for the reply. Now i maybe wrong but the sticker on the back of the box says it is 1.17cuft. Is that not good?? btw not enough room to mount 2 12". I thought about that but the face of the box won't allow it...

Loke

DeadlySones

iTrader: (4)

OH... your original post said 1.7cuft... 1.17 should be perfect for the 2 -10's sealed.

loketar

ahh right you are, sorry for that. I just checked again and indeed it says 1.17 cuft. so that is awsome. And thanks so much for your replys.
Cheers, Loke