Which amp is best?
I have a 1200 watt JBL sub, can any buddy please recommend me that Sony Xplod 800W 2-Channel Amplifier (XMZR1252) or Sony 4-Channel 600-Watt Xplod Amplifier, XMZR604R is best for this sub.
Thanks |
First what the model and voicecoil configuration for this sub?
If the total impedance for the sub is 4ohms then the XMZR1252 is the "best" of both. Why only those 2 amps? |
Save your money.
Xplode is garbage. Try Audioque 1200d. Is the sub 1200rms? or peak? |
Originally Posted by Nightendday
(Post 468093)
Save your money.
Xplode is garbage. Try Audioque 1200d. Is the sub 1200rms? or peak? |
can i get a 2Ch amp or 4Ch amp and can i bridge my speakers with 2Ch amp.
Can any one tell me whts a difference between MONO & Stereo amp and which one is suitable for my JBL 1200 Watts peak 300RMS (GTO1202D). Thanks. |
Originally Posted by mike007
(Post 468102)
can i get a 2Ch amp or 4Ch amp and can i bridge my speakers with 2Ch amp.
Can any one tell me whts a difference between MONO & Stereo amp and which one is suitable for my JBL 1200 Watts peak 300RMS (GTO1202D). Thanks. |
i think any amp will be good as long as it's a JL.
|
Its too bad you didn't have a subwoofer that was a dual 4 ohm voice coil configuration, instead of dual 2 ohm. You're going to want an amp that does 300-400W for that sub. If the sub could be wired for a 2 ohm load, you could find a smaller amp that does 300W @ 2ohm. But since you're looking at a 4 ohm load, you're going to have to fork out more money on an amp that capable of that much output on a higher resistance.
http://www.pioneerelectronics.ca/POCEN/Products/Car+Audio+Video/Amplifiers/GM+Series/GM-5400T <<< Link to the amp I'd suggest... But you won't get the power you'd need to get the most out of your sub. http://www.pioneerelectronics.ca/POCEN/Products/Car+Audio+Video/Amplifiers/PRS+Series/PRS-D1200M You could always get this amp. It does 600W x 1 @ 2 ohm. You'd also have to buy a 2nd sub, identical to the one you have. Each sub would then get 300W. It'd be a nice match. |
Originally Posted by Father Yuli
(Post 468178)
i think any amp will be good as long as it's a JL.
Has anyone ever accused you of being an instigator?? Mike007, because you have a dual 2ohm voice coil driver, you can go one of 2 ways....either find a mono Class D amp that produces 3-500W @ 1ohm and wire the VCs in parallel, or get an A/B 2 channel amp rated @ 75-100W per channel, wire the VCs in series and bridge the amp to run the driver at the correct load. Of the 2 amps you asked about, the XMZR1252 is a better choice for your driver....having said that, it is not a great amp for sub(s) and may leave you wishing you had saved a little more $$ for a better one. Even if you decide to get the Sony amp, make sure you get a proper enclosure....it will play a bigger role in delivering good sound than the amp will. HTH |
All times are GMT -5. The time now is 05:38 AM. |
© 2024 MH Sub I, LLC dba Internet Brands