tigersvain

Hi, i just purchased two 12" subs ( http://www.audiobahn.com/Audiobahn06/pages/woofers.html ) the ones named Flame Q subwoofers with the part # AW1206T in the lil chart thing, anyways, my question is what should i run for an amp on these? 2 channel? mono? 4 channel? i'm confused, and for amp power what should i be looking at? any reply is appreciated.
Thnx

Matt

Brad-S.A.

iTrader: (35)

You can use a 1 ohm stable monoblock or a bridgable 2 channel. As they are DVC subs.

tigersvain

ok but what about power? these subs have 1100watt rms each and i'm runnin 2 of them, so do i get an amp with 2200watt rms? or one with 1100rms and bridge it? lol really new to this so i'm probably sounding like a complete retard to some of you lol

zzzzzzz

iTrader: (5)

if you get an amp that can do 1oms you can run two 2oms subs so it has a 1oms load
try looking at this http://www.the12volt.com/caraudio/boxcalcs.asp