amp starts in protect but switches to norm
 

the title really says it all, the amp starts in Protect and then switches to norm. in less then a second, is it part of the rutine? the amp runs fine after. i've never heard of any amp doing this, the amp is a....

Hypnotic Z2500.1D - 2500 Watt Monoblock Amplifier

SPECIFICATIONS
4ohm 14.4 Volts: 1 x 750 Watts
2ohm 14.4 Volts: 1 x 1250 Watts
1ohm 14.4 Volts: 1 x 2500 Watts
Capability: 1Ω Mono
Input Sensitivity: 200mV - 5.8V
Input Voltage: 11-14.4 Volts
Signal to Noise Ratio: 90dB
THD @ Rated Power: < 0.5%
FEATURES
Class D
Audiophile grade components
High efficiency mosfet design
On-board variable precision
18db per octave x-over
Variable On-board bass boost @ 45Hz 0-18db
Subsonic filter: 20Hz - 50Hz (Class D amplifiers)
Bass remote gain control included (Class D amplifiers)
Hypsink technology (Heat management system)
Translucent, blue illuminated Hypnotic logo

Any idea would help a ton, thanks guys.

Lots of amps the light will go red then green, on initial startup this is only for the first second or two.

perfect thanks bud