Audioque 1200D + RE Audio SE10 10" Dual 4-Ohm SE-Series Subwoofers?
 

Just wondering if this would be a good selection. I hope to build something that pounds pretty good but doesn't cost a fortune. Also, will I have to bridge the subs and can I run it at 2 ohm?

Links:
http://www.audioque.com/aq/AQamps.htm]AudioQue
http://cgi.ebay.com/RE-AUDIO-SE-10-1...d=p3286.c0.m14]eBay

Thanks!

its a 1 ohm amp. you need a sub that can be wired to 1 ohm. so dual 4 ohm is a no go.

So two of those 4 ohm dual subs won't work with that amp? Sorry for the silly question. Again I'm new to all this...

oh 2 of them, yah that would work.

thanks. appreciate your help. so is this a setup you'd recommend?

not enough power but it should be ok.

How much power do you figure I can get out of it?

510X1 @ 4 ohm,
870X1 @ 2 ohm,
1200X1 @1 ohm

Thanks alot :)

What method should I used to connect the amp to the two 10" subs? Parallel? thx