Component speakers and Amp combination question
#1
Hello,
For the past three years I had a Rockford Fosgate Punch Power 200a1 mono amplifier hooked up to two 12" Kenwood HQ's subs in my '97 Accord EXR 4-door sedan.
I have since removed the subs and am looking to purchase speakers that would fit the factory locations in my car (both in the rear and in the doors).
I looking into the Infinity Kappa series speakers, specifically the Kappa Perfect 6.1 6x9 speaker line.
I would like to know your opinion if these Kappa speakers are compatible, and would sound good with my Fosgate amp and if the speakers are able
to handle the power output of the amp.
If not, then can you recommend speakers that will sound good with this amp and fit the factory locations.
Thanks,
Rico
For the past three years I had a Rockford Fosgate Punch Power 200a1 mono amplifier hooked up to two 12" Kenwood HQ's subs in my '97 Accord EXR 4-door sedan.
I have since removed the subs and am looking to purchase speakers that would fit the factory locations in my car (both in the rear and in the doors).
I looking into the Infinity Kappa series speakers, specifically the Kappa Perfect 6.1 6x9 speaker line.
I would like to know your opinion if these Kappa speakers are compatible, and would sound good with my Fosgate amp and if the speakers are able
to handle the power output of the amp.
If not, then can you recommend speakers that will sound good with this amp and fit the factory locations.
Thanks,
Rico
#2
You said the amp was mono meaning it only has one channel, This means you should only run one speaker of it (sub are an exception. You might want to look at sellingthe amp in the for saleforum and buying a four channel amp out of there
Thread
Thread Starter
Forum
Replies
Last Post
andrewsfm
Enclosure Design & Construction Help
0
09-28-2008 11:13 PM
JASON_ALT13
General Discussion
3
02-09-2005 08:53 PM