Phoenix Gold had one in there line of parts at one time

yea it definitely takes a long time to heat it up with the torch for it to take.

I use open ended lugs so I insert the wire then heat the lug for maybe 3 minutes and add the solder until the opening is totally filled.

My knukonceptz wire started to melt the shielding on nearly every wire but my welding cable was totally fine. With the knu wire id wait for it too cool down a bit then kinda mold the shielding back into the basic form it should be in then add heat shrink and tape around it.

i think your confusing hard solder with soft solder
two different compositions and two different melting tempatures

what i've used before is just take ap iece of wood, (hoping you have a vise at home on a work bench) and drill a hole the size of a drill bit, and then take a wide flat head screwdriver, and put it in the hole.. then just take some clips and hole the piece of wood there with the bit, and then just take the wire you want to crimp, and just start turning you vice, and then keep going, but not too much to cut through your terminal.. worked good for me, since we were doing a few, smacking it with the hammer and screwdriver ust went right through the terminal lol..

well when it comes to solder i dont know how well that would work, the problem i have had is the solder would melt and then that causes a chance for things to short out or even catch fire :(

If your power wires get hot enough to melt solder, then you've got a lot more problems.

what happend was that i upgraded my system but not the fuse, so the solder in the fuse would melt away.