i found the email. if they do have some and i have a load of cash i would grab as many as i can lol 3 pairs maybe

 

hi there i just recently but a massive dmx 15inch with 4 voicecoils for 499$ and was wondering what kind of amp i should get for it. my friend has a massive RS-150 2 channel he will sell me but to be honest i dont know much about hooking up the equipmnt and was hoping i could get some advice. does numer of voice coils, 2 or 4, matter with which kind of amp u get. thanks

 

you can wire down to 1ohm on those quad coils. and an amp to power them would be anything at 1ohm from 1500 to 1700watts rms. they handle 3000watts rms only for burps not music.

where did you get your subs????? can you ash where you bought them if they have 2 recones for CW-12 PLZ lol i really dont want to get rid of these

 

Sound Solutions (Ken) is 3 hours away from me in Victoria (Colwood) BC. I can dig up their number if you like.

massivemusic, drop me a line if you like, 1-888-881-9911 or msn me to forbidden@telus.net

You should be looking for an amplifier that makes maximum output at 1 ohm, ideally a class D mono amplifier. Your budget will determine the Quality or Kwality of the amp to look at.

 

ive contacted them thru email. and they asked me if i was a dan that quit recently? emailed again and never got an awnser. massive audio told me to contact them too. as they might be the last ones to have the recones

 

pulled out the sub and one sub is fine. the other sub has 4 ohm coil and the other coil is 8. when i go close to the coil with the MM is says 4ohm. what im guessing is that the tensil lead is screwed.

NOW can i fix this??? the sub is fine.. its just the tensil lead that is screwed up... can i saulder a wire to it?? lol

 

anyone??? i need to know if i can fix the tensil lead on this sub so i can do it and pop it back in asap

 

yes you can but to do a good job you will need to remove the dustcap so you can solder the new lead to the vc

 

lol there is no dust cap. its all one cone. and i dont plan on taking anything apart. the only thing that appart right now is the cone, coil and spider. ( it removes with screws )

i can have easy access to the tensil lead as close to the coil as possible but thats it.... could i fix it at the last 1mm from the VC ????

 

actually what you think is the cone is actually the dustcap which covers the entire cone