Car Audio Forumz - The #1 Car Audio Forum

Car Audio Forumz - The #1 Car Audio Forum (https://www.caraudioforumz.com/)
-   General Discussion (https://www.caraudioforumz.com/general-discussion-10/)
-   -   My attempt at a stealth install: 07 FJ cruiser (https://www.caraudioforumz.com/general-discussion-10/my-attempt-stealth-install-07-fj-cruiser-70033/)

M.C. Ryan 07-11-2008 09:24 AM


Originally Posted by alphadawg (Post 366355)
not sure how stealth those big pods on the dash will be...but your install is looking solid!

I agree... too bad you couldn't keep the factory deck... that's the stealth I went with, anyone looking in just thinks it's factory (until they see inside the trunk)

AAAAAAA 07-11-2008 12:34 PM

I agree the pods aren't stealth, my plans have change yet again, and kicks will be built.

I had planned to keep the stock deck but, it just sucks way to much. Navigating any kind of MP3 CD is a useless endeavour.
I do plan on getting the stock deck face to go over my deck eventually. But first up will be subs, and they will be stealthy as well.

Junkinthetrunk 07-23-2008 07:27 AM

I'd like to know how those 3" mids sound...................

Father Yuli 07-23-2008 10:29 AM

you really know wtf you are doing. looks sick.

AAAAAAA 09-28-2008 06:46 PM

Decided to switch up the equipment, 5 1\4 pioneer PRS comps and premier shallow mount 8 for the doors.

http://memimage.cardomain.com/member...jpg?150216-272

The shallows are pretty shallow, about the same mounting depth as the midranges
http://memimage.cardomain.com/member...jpg?150216-272

All of them together
http://memimage.cardomain.com/member...jpg?150216-272

During the install, one of the pioneer sub\midbase didn't work, but luckely I noticed that pressing on the negative terminal made it play a little, so I took apart the terminal and re-soldered it. I was pretty happy, didn't have to return it
http://memimage.cardomain.com/member...jpg?150216-272

managed to get my pods to look like the stock panels but without cuting up or using the stock ones.
http://memimage.cardomain.com/member...jpg?150216-272

Of course I did seal off the back as can be seen from the top pictured pod
http://memimage.cardomain.com/member...jpg?150216-272

Forgot one important thing when I was ready to put the pods in.... didn't have any more poly fill.... so I had to improvise
http://memimage.cardomain.com/member...jpg?150216-272

Looks not to bad with those sexy PRS midranges
http://memimage.cardomain.com/member...jpg?150216-272

Here are the drivers in the doors, they are replacing dayton RS series inch woofers. Lucky for me, they both had the same cutout so an easy swap. I did have to cut up the door a bit to make it fit though.
http://memimage.cardomain.com/member...jpg?150216-272

Passenger side pod, while fitting the mid, I didn't take into account the logo on the grill. Oups.
http://memimage.cardomain.com/member...jpg?150216-272

Drivers side is the same
http://memimage.cardomain.com/member...jpg?150216-272

I riped out my dash pods and I am testing out tweeter locations, but so far corner dash seems pretty good sound wise.
http://memimage.cardomain.com/member...jpg?150216-272

And here is might sound setup, true RTA with with behringer mike, you can also see my reflection hehe
http://memimage.cardomain.com/member...jpg?150216-272

Here is what it's in
http://memimage.cardomain.com/member...jpg?555915-272

2 8's AKA Jeepbeats 09-28-2008 09:57 PM

Very nice work. Are those 8's the Premier ones, TS-SW841D's? How do they stack up in bass response, vs. the Daytons? The Daytons are the RS225's?

AAAAAAA 09-30-2008 06:04 PM

Yes they are the premier ones, so far they seem to play lower then the RS225's but they are not as loud, I think they want more power. Dayton was better at midbase and played higher, the pioneers play lower and are less efficient.

I measured relative loudness of the 2 using true RTA
DAYTON RS
100hz -2.4 DB
80hz -3.4
60hz -8.2
50hz -8.8

DAYTON RS
100hz -4.2 DB
80hz -6.8
60hz -11.3
50hz -8.9

Closer to 0, the louder it would be. Of course the daytons were broken in and the pioneers are new.

I need more time to experiment before more comments.

I also decided to clean up the tweeters, pictures are pretty dirty, they look better in person I would say.

http://memimage.cardomain.com/member...jpg?251215-274

http://memimage.cardomain.com/member...jpg?251215-274

Epica-Go-Boom 10-01-2008 08:40 AM

looks good but I am not sure about those kicker panels. If it was my car I know atleast the one on the drivers side door wouldnt last long because it that pic it looks like it sticks out pretty far... but I guess they are called kicker panels for a reason :D

AAAAAAA 10-07-2008 06:58 PM

I haven't kicked em yet, nor has the careless wife. They really don't stick out to much I find.

Updated though, those pioneers are not meant for midbase dutie. They are pretty anemic in output and have no midbase. Dayton's are 100% better.

Changed the finish on the tweets
http://memimage.cardomain.com/member...jpg?362316-281

http://memimage.cardomain.com/member...jpg?362316-281

Next up, new midbases and more door work.

AAAAAAA 10-08-2008 06:47 PM

The new midbase has arrived!

http://memimage.cardomain.com/member...jpg?542716-282

It's the middle one... yummy peerless!


All times are GMT -5. The time now is 01:12 AM.


© 2024 MH Sub I, LLC dba Internet Brands