I have 1999 F-150 truck, club cab, 4 door. I would like to put in subs under my seats if at all possible because i like to use the back seat. I was wondering what would be the best sub to put under my seats, in tight spaces if at all possible. What is the best way to face them? Should i do this myself or just go get it professionally done?

I am also having some problem with my speakers on my back doors rattling. Any ideas.

I'm kinda new to the car audio world so any suggestions would help. Thanks alot

 

well well, I know alittle about this. I have a 2000 F-150.


with out a seat lift a 10w0 JL audio will fit 2 of them.
there is a seat lift avaliable for our trucks, I put in the 3" lift and now have 2 PWD 304's MB quarts 12" subs.

please check out www.fordtruckworld.com

go to the fourms and check out the manitoba chapter, were looking for more members.
I go by Icon there to.
were haveing a BBQ on the 14th in winnipeg, you are welcome to come, just let us know at above site.

I'll see if you've gotten the help you needed tonight if not I'll reply again.

 

oh, if you do make the BBQ I'll pop off your back door panals and look around, I'll also bring some sounddeadner and new rear door speakers if you like. < I have my stock ones, you can have them if yours are blown.

if there not blown we can sound deaden the rattles. C ya.

 

There's not much room under the rear seats. I measured under 6"s in some spots....so up/downfiring is the only option and the bottom of the seat is metal so I guess downfiring is the only option......even then mounting depth is extremely restricted.

I'm doing an install for freind in a 99 extended-cab F-150. Since there's not much headroom to begin with he didn't like the idea of raising the rear-bench. So we've decided to remove the 40 from the 60/40 rear-bench. Then comes the B15..... [img]graemlins/headbang.gif[/img]

[ June 10, 2003, 10:51 AM: Message edited by: mcchicken ]

 

hey thanks for all the help guys. I will join the other forums tomorrow.

One more question--- Think that i could make boxes by myself, or should i just get it professionally done?

 

make the boxes,there not that hard. pick up some MDF at home depo and they will even make the cuts for you if you don't have a table saw.

predrill your holes and all will be ok.

 

Hey Guys

Sorry I couldn't make the BBQ. Probably would have been fun though.

hyea I was wondering where I could find some of that sound deadener. I was also having some trouble finding the seat lifts. Any ideas.

I found some cool sub designs at www.subbox.net.

thanks for all your help
[img]graemlins/beer.gif[/img]

 

seat lift here: http://www.lmiwelding.com/

hoods for our trucks here:
http://www.f150online.com/galleries/...w.cfm?num=3091


and yes you did miss a good BBQ

picts here: http://www.fordtruckworld.com/mygall...87&album=21970

my ride here: http://www.fordtruckworld.com/showow...=3&album=21970

http://www.fordtruckworld.com/galler...ter/268104.jpg