old school RF?
anyone know much about these amps?
Rockford Fosgate 100DSM Output Power at 11.6V (20Hz ∼ 20kHz): 2 x 50W @ 4 ohms (<0.05% THD) 2 x 100W @ 2 ohms (<0.1% THD) 1 x 200W @ 4 ohms bridged (<0.1% THD) S/N Ratio: >110dBA Bandwidth: 15Hz ∼ 100kHz (±3dB) Freq. Response: 20Hz ∼ 20kHz (±1dB) Fuse: External 40A Dimensions: 11.6" x 9.6" x 2.6" (29.5cm x 24.4cm x 6.6cm) Manufactured in 1993 http://ampguts.realmofexcursion.com/...sm/inside1.jpg http://ampguts.realmofexcursion.com/...m/outside1.jpg http://ampguts.realmofexcursion.com/...m/outside2.jpg stable below 4ohms? i hear the 60ix,100ix etc are considered cheater amps? same for the 100DSM? i can grab 1 for $50 but im not sure if i will be able to use it unless its 2 or 1 ohm stable |
Yes you will find it underrated. Not a huge cheater amp designed to be loaded down like a 225HCCA from the same era but it is underrated power wise.
It is rated to a lowest of 2ohm stereo. It will do 2ohm mono but will get warm and it will shorten the lifespan of the amp. I don't recommend 1ohm mono. |
i've had a 100rf which i loaded down to .375ohms and ran no problem. Citrate and willcann will confirm it.:smokin:
|
was that jsut for comps or did u run that low daily? if i ran it at 1 ohm it be in my daily driver powering 2 10" kaption SPLs(4ohm DVC)
but for now it would be running 2 10" JLW0s at 2ohms until i sell them |
just for comps. for daily don't bring it past 1ohm or like hardwrker says it will get warm and will eventually go boom:smokin:
|
so u think it can handle 1 ohm then? would wiring up a fan give me any extra insurance? lol if it blows its only $50 but id like to keep it running and if a $10 fan helps that be great :smilie_da
|
1ohm is a dumb idea.
The 100DSM or ix was optomized for 4ohm mono. Yes it will operate at 2ohm mono but it doesn't make any more power. According to the Power Cube, it actually made less. It's a steal for $50. Run it 2ohm stereo for ~160-180watts per channel. The Power amps were the low impedance amps back then: Power 50m, Power 500m, Power 50x2, Power 250x2. |
picked it up, nice little amp:smilie_da i brought it inside to take a look at the internals and i cant get 1 allen key screw out, not sure what to do as i tried a pair of vice grips on it aswell....might have to grind it off:sly: lol
|
Originally Posted by _HeC_
(Post 330294)
picked it up, nice little amp:smilie_da i brought it inside to take a look at the internals and i cant get 1 allen key screw out, not sure what to do as i tried a pair of vice grips on it aswell....might have to grind it off:sly: lol
|
thanks for the tip, ill try the dremel abit later
anyone know why im getting music out of my subs? theres no LPF/HPF/full switch on it, theres only 2 gain controls and bass/treble :( |
All times are GMT -5. The time now is 05:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands