bass_4_ever

Hey all, me and a few buddies just finished installing a 12" FI BTL in a guy's car. Did the big 3, ran all wires, etc. We played it, sounded amazing. 2-3 days later when playing at higher volumes, both amps (mono & 4 channel) cuts out. Theres no more sound that comes out of them but the amps stay powered on (all lights are on, no protection light or blown fuses).

At lower volumes both amps play fine, but when the volume is turned up past a certain number both amps cut out. Only when the car is restarted do both amps come back on.

Any ideas what might cause this?

Set-up: Alpine 4 channel, Alpine speakers all around, Hifonic amp (3200wrms - dont remember the model), all 0 gauge through the car, 250 amp alternator, 1 red top up front, 1 kinetik hc2000 in the trunk. I think either an Alpine or Pioneer deck

Dukk

Both amps cut out at exactly the same time? If so, I would look at the deck. Try metering the voltage at the deck when hammering the system.

bass_4_ever

Thanks Dukk! Both amps cut out at the exact same time. What exactly should I be looking for voltage wise on the deck?

DMM to RCA outs, and as the volume goes up the voltage should rise too... then see if the voltage just cuts out and goes back down?

chigger_ns

Try running a heavier ground to the Deck. I had to because it drew too much power from the factory ground wire. you also may need to run another battery wire for the deck too.
But first do that ground wire...

Dukk

Measure the voltage on the batt lead. I'm thinking the voltage at the deck is dipping and it's shutting off the output section.

bass_4_ever

kk i'll give it a try if i see him tonight.

But if the voltage was too low, or the ground wasnt enough.. wouldnt the equipment.. or atleast the deck.. shut off? Nothing turns off, the sound is the only thing that gets cut out.

chigger_ns

I had only the sound cut out in the internal deck amp. I never had an external one hooked up at the time.