ufknrun

Hi all,

I'll be adding a subwoofer to my system soon and would like your recommendations for a single woofer setup.. here is the equip I have installed already:

Alpine 9883 head unit
Infinity 6.5" 2 way fronts
MTX thunder 6x9 rears

Amp is a Rockford Fosgate Punch 500X 4ch. I'd like to power the 6x9 with 2 of the channels and bridge the other two channels to a 2 ohm sub.

The amp manual shows the output to be 250W @ 4 ohm (bridged) so I'm assuming a 500W rms power rating will be required for @ 2 ohm.

My last system (many years ago lol ) had a RF punch 200 bridged to 3 x 10" JL W5 subs in a sealed box in the trunk of a civic HB and I loved the sound but I'm older now and want to keep it simple. This will be going into an '05 civic coupe.

Any suggestions or comments are appreciated!

FusionMadsen

iTrader: (4)

No, bridged isn't 2 ohm stable, unless you have a super amp that has 4 channels that are 1 ohm stable.

With 200w at 4 ohms, I'd say get an entry level MTX sub with a single 4 ohm coil.

ufknrun

oh poo... I thought I had this all figured out lol

So looks like I can run 250W rms to a 4 ohm sub... any other suggestions?

AyZe

Type E's have worked very well for me wen i didnt have much power.

theif

1 w7 8". Sounds GREAT on 250.