I have a RF power 2FR1000bd pushing some older audiobahn subs (until my shivas get here on monday). When I have it turned up so its hitting hard, some notes will just kill the power to my subs, no bass. The amp stays on though, does not turn off. I turn my car off to cut power to the amp, then turn it back on and it works. But When I turn it back up and it hits a real deep note, it shuts back off. Anyone know what would cause this? Or is it just my amp cutting out for some reason?
|
impedance is dropping lower than what the amp can handle and is going into to protection.
by shutting the car off/on you are reseting the amp. |
The subs are dual 6 ohm. I hooked one up parallel to run it at 3 ohms. It still cuts out when it hits powerful notes.
|
check the impedance of your + and - your conn to your amp with a multimeter.
what is that impedance? |
^ Impedance is for AC.. not DC.
I think you've got a bad ground. Where have you got it grounded? |
Originally posted by Mike MacAwesome: ^ Impedance is for AC.. not DC. I think you've got a bad ground. Where have you got it grounded? |
I'm banking on voltage drop. For a start I would clean up your battery connections, amp ground, and check the water level in your battery )if possible)
|
Yea, Im going to get some good connectors, put my circuit breaker in that i got today, and clean it all up. Im gunna put 4 gauge wires under my hood too. See if that helps anything.
|
All times are GMT -5. The time now is 01:09 PM. |
© 2024 MH Sub I, LLC dba Internet Brands