When hooking up a 2nd amp....
#1
Do i just splice the remote wire and run it to both amps?
I have 4 guage from the bat to the amp, and i need 8 for the 2nd amp im installing, so i need a distro that takes in 4 and spits out 4 and 8?
any help would be appreciated
I have 4 guage from the bat to the amp, and i need 8 for the 2nd amp im installing, so i need a distro that takes in 4 and spits out 4 and 8?
any help would be appreciated
#2
Yeah you use a distro block and yes you splice your remote wire if you are going to be running 2 amps.
Make sure you fuse the distroblock properly as you are going to be using two different amps that will pull two different amounts of current.
SHY
Make sure you fuse the distroblock properly as you are going to be using two different amps that will pull two different amounts of current.
SHY
#3
well one amp is a mmats d300hc thats running of an 80 amp fuse just fine....and the other amp is a USX 4065 should i run a 50 or less to that? or what should i use,
#4
devide the power by the voltage. That should give you a working number and yeah around 50 should do.
This is roughly speaking, you can get all technical and all but, this should do
SHY
This is roughly speaking, you can get all technical and all but, this should do
SHY
Thread
Thread Starter
Forum
Replies
Last Post