hi guys i have this amp

http://www.jbl.com/car/products/product_detail.aspx?prod=GTO3501&Language=ENG&Coun try=CA&Region=USA&cat=AMP&ser=GTS

and these subs

http://www.pioneerelectronics.com/PUSA/Products/CarAudioVideo/Subwoofers/Champion/TS-W302R?tab=A

and was wondering if i could wire them like this



i am asking because i dont know if my amp can do this

 

the 1st line of your specs says 360wrms @ 2ohms , in turn yes you can do a 2ohm load with your amp.

 

sweet jw id be better off with the 2 ohm as opposed to the 4 ohm in turn the subs would hit harder??? am i correct?

 

well it is a higher power, soo if you had the same subs, but went 4ohm it would be less power=less boom...

 

you can sureley wire them in this manner but the condtion is that wire should be proper

 

the only thing is it doesnt say any where that i can bridge the amp thats the only thing that worries me or should i just wire it the simplest way each speaker + to + and - to -???

 

yes, its a mono block so its already bridged, (internally)