Port Flaring
#12
#16
lol, looks like the one I made a little while back. Assembling with CA glue and a lil activator makes for instant use. I made and installed it in less than an hour. I gained .3 using it. Only used a lil silicone to adhere it to the enclosure.
Last edited by DeadlySones; 08-18-2010 at 07:06 PM.
#17
here's the finished port with box...
port walls are 1" thick using 1/2" mdf offset so each piece of the port interlocks to the other
also, the back wall of the box is 3/4 mdf and 1/4 reinforced resin, wire mesh stapled down and resin poured over
port walls are 1" thick using 1/2" mdf offset so each piece of the port interlocks to the other
also, the back wall of the box is 3/4 mdf and 1/4 reinforced resin, wire mesh stapled down and resin poured over