Amp?!?! Wiring!?!?!
 

Im going into a stereo Comp. On the 14th And im running Two 200watt Rms Kenwood Subs And One sony 380 watt Rms and i need 2 buy an amp so if anyone has any suggestions or anything they would like to sell me for Around the $300 Dollar Mark Let me know but ill need it by the 12th.

Also if i was 2 get a 800watt Rms MonoBlock Clarion Amp How should i Wire it to get the most resistance? Power? Im Wirirng All three subs into one ported box.

Thanks
Andrew

why that set of 3 ?
run the 2 same subs in the box you will be happyer in the end
you also need to tell us 1 vc or 2 vc 2 ohm or 4 ohm vc

Single Coil, 2ohms each why run just the two subs?

are the subs 1 vc or 2 (1 set of wires or 2 )?
1 3 sub do not do the best
2 if you are going to run all the same subs then
if you have 3 rocks and toss them into water and thay all hit at the same time it looks good now you have 2 rock and bob has 1 rock and you try to get your rocks and bobs rock to hit the water at the same time (what does the water look like
run 1 sub or # of 2 ,,,2,4,6,8,
you also need to know what is the ohm load to the amp

there all one set of wires.

make 2 boxes 1 for 2 subs and 1 for 3 test then tell me
sell off the odd one and get 2 more of the same subs

k Thanks ill try that as soon as i get my car back.

That was beautifull:D

Ok So ive decided to sell the kenwood subs and buy two more sonys
The Sonys are Single Voice Coil, and 4ohms.

How Should i wire these?

sell the sony .
ok sell the kenwood too
and get all the same subs but get 2 or 4 not 3