D.Sanchez

Hey folks, im looking for installers out there that have done an alarm in an 06 dodge ram quad cab, the truck has individual door pin wires which ive had to diode isolate, everything works fine untill 30 seconds after the dome light goes out, then the alarm sees a false trigger and sets the truck off, directechs, staubtech, and bulldog all do not mention any of this, ive done many alarms yet havent seen this one yet, im on a time constraint budget and need to figure this out as soon as possible any help would be much appreciated!

SPL Inc

were the door pin wires purple, purple/white, purple/grey, purple/yellow? Each door may have positive and negative doorpin wires. Be sure that all of the polarity is correct along with the input of the brain. Is it a bulldog that you installed?

D.Sanchez

Ah i got it folks, just a bad day for me in the brain department, the dodge's BCM sends a querey signal 30 secs after the dome lights go off and then again every hour on the hour... not only do you have to diode isolate the door pins individually from eachother to the brain of the alarm, u need cut the door pin wires going to the BCM and diode isolate them aswell, this allows the BCM to recieve door pin signal but it cannot send the querey signal back.... it was a compustar 2 way fm 8000 btw thanks