my deck install
before and after

 

Thats similar to what i wanted.. the double din series.. Nice...

 

thats nice, i love it

 

That's a beauty deck. Looks nice.

It's great having a digi cam, just a little advice, for forum posting resize the pic to 500 pixels wide and it will fit really well.

 

Is that in a GM vehicle? If so you did a damn good job. Looks good.

 

thanks its a crown vic
the holes a 1-1/2-1-3/4
i had to modify the heater duct to get the unit to sit more level
and quite a bit od dash modification
the ford unit sits on quite an angle back which makes viewing not very good


what progam do you use to resize your pics
i used paint and reduced the pic by 50%

 

usually a lower res setting will make it smaller. Do that from your digicam. Is that what you had in mind fever?
PS. Sweeeet deck. nice install!!

[ July 30, 2004, 05:46 PM: Message edited by: Nissan Guy ]

 

With my cheapass HP digicam I received a cd that d/l stuff. Part of it was from ACDSee that allows me to resize, levels, rotate, zoom, etc, etc. Kind of a cheap photoshop. I think you can try a free copy for a while at the link. Did your camera come with any software?

I make new copies of pics I want to put on the forum and size them to 500 pixels wide. Length doesn't matter as much. Looks small on my comp, but fits the forum really well.

Right clic and properties any pic and you can see the size. Gives you an idea. The pics you posted pinhead were ~1130 x 850.

Gene

[ July 30, 2004, 07:08 PM: Message edited by: Fever ]

 

its a canan a80 its a 5 mega pixel
i tried the software that i came with but i didn't dig to far
i will try again

it came with arcsoft photo impression 4

 

Canon makes great digi cams. I could tell your pics were very sharp. My HP is only 2Mpixels.

I'm sure your software will do it all. Check it out.

[ July 30, 2004, 07:49 PM: Message edited by: Fever ]