Kenwood Install help
Kenwood Install help
I just installed a Kenwood KDC-MP332 and everything works fine but when the car is in run the deck turns off completely and wont turn back on but when it is in accessory mode it just keeps turning on and off does anybody have any ideas
I have a 98 Saturn SL1
I have a 98 Saturn SL1
Last edited by rmorris003; Jan 7, 2007 at 04:37 PM.
On another forum seems like its the voltage dropping and the connection is bad for either the ground or the yellow wire so i will test them another day
Thats the vid of the problem
http://www.youtube.com/watch?v=Sk5i3ZTaOec
Thats the vid of the problem
http://www.youtube.com/watch?v=Sk5i3ZTaOec
Last edited by rmorris003; Jan 7, 2007 at 04:46 PM.
it works fine when the engine is on but it resets when it is off and if i dont start the car it will not even power on in run mode, the engine was on before the vid was shot and the sound is directly from my digital camera, my other deck worked fine too before i pulled it and it was a pioneer avh-6400cd
Last edited by rmorris003; Jan 7, 2007 at 04:57 PM.
well it seems like there is a short somewhere because when driving to school the deck resets it self when using turn signal and when i put it in park when i got home it reset too, so im gonna have to just pull it and then re wire it to the gm harness that i got extra instead of using the garbage splices that future shop used.
Thread
Thread Starter
Forum
Replies
Last Post
Lastmboy
General Discussion
3
May 3, 2008 01:36 PM
metso
Install related
8
May 24, 2007 03:49 PM



haha
thats good
