Install related Need a car audio install related question answered? Have a tip you want to share, post in here!

Pioneer GM-X904 Amp question

Old Nov 30, 2004 | 09:06 PM
  #1  
Kwalsh24's Avatar
Thread Starter
50 Watt CAFz'r
 
Joined: Dec 2003
Posts: 375
Post

I just purchased this pioneer GM-X904 amp off of user trk2loud today and was wondering if anyone out there has had any experience with it and or if anyone would know where I can get a manual for it? This is a question for you Pioneer guys lol.

Also I was wondering with this amp should all the channels be connected? I was testing this out. I put a imput into A/B (A/B/C/D is my example of eache channel in a 4 channel amp) and when I tested this I found that when I connected the (-) line to the (-) line on channel C or D there would be audio comming out when there is no input source even in channel's C/D

Does this sound correct?
Old Dec 1, 2004 | 03:13 PM
  #2  
Hardwrkr's Avatar
2000 Watt CAFz'r
iTrader: (5)
 
Joined: Mar 2003
Posts: 3,542
Post

I've installed it. Sounded decent and the customer was very happy with it with no troubles if that helps you. Not the best at low level detail and it is not the warmest sounding amp but a decent performer for the cost.
I have seen a bench test on this amp and it did:
56rmsx4@4ohm
161rmsx2@4ohm bridged
I cannot remember the test voltage though.

Other than that I can tell you from digging through the Pioneer catalogue that this unit is from 1996 and specs are:

Continuous power (20-20kHz, 0.04%THD
-50x4@4ohm
-75x4@2ohm
-150x2@4ohm
-2/3/4ch capability
-no current limiting
-S/N ratio 105dB
-frequency response 10-80Khz
-variable low pass filter 50-120Hz, -12dB
-variable high pass filter 50-120Hz, -12dB
-independent front and rear input gain controls 400mv-2v
-gold plated dual inputs
-gold plated thru-put terminal
-PWN power supply
-fan cooling system
-high speed mos-fet power transistors
-high performance balanced isolator circuit
-made in USA
-9-7/8x2-1/4x12-1/4"
Old Dec 1, 2004 | 08:04 PM
  #3  
Kwalsh24's Avatar
Thread Starter
50 Watt CAFz'r
 
Joined: Dec 2003
Posts: 375
Post

Hmm wish I could find a manual for it. lol nothing is even listed on the neb but I guess its cause its old. hope it sounds decent otherwise its gone lol. But would be hard to sell since it old.

[ December 01, 2004, 09:05 PM: Message edited by: Kwalsh24 ]
Old Dec 8, 2004 | 12:34 AM
  #4  
Pioneer Guy's Avatar
500 Watt CAFz'r
 
Joined: May 2004
Posts: 597
Post

Hi Kwalsh24,

I too cannot supply you with a manual due to the amps' age. If you have the time, try calling the customer support line below & see if Pioneer can still supply you with one.
Good luck!
Old Apr 29, 2008 | 01:00 AM
  #5  
madmax's Avatar
0 Watt CAFz'r
 
Joined: Apr 2008
Posts: 1
gm-x904 manual

i have the complete manual for this amplifier, and also have the aplifier itself brandnew not out of the box yet since 1995
Old May 4, 2008 | 06:56 PM
  #6  
Kwalsh24's Avatar
Thread Starter
50 Watt CAFz'r
 
Joined: Dec 2003
Posts: 375
oh yeah? how much?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Scottie
General Discussion
11
Jul 1, 2009 06:18 PM
jeolandest
General Discussion
0
May 14, 2009 02:27 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:37 PM.