Car Audio Forumz - The #1 Car Audio Forum

Car Audio Forumz - The #1 Car Audio Forum (https://www.caraudioforumz.com/)
-   Install related (https://www.caraudioforumz.com/install-related-17/)
-   -   Removing Timer on remote starter? (https://www.caraudioforumz.com/install-related-17/removing-timer-remote-starter-15577/)

fiero-silva 02-28-2006 03:34 PM

Removing Timer on remote starter?
 
Anybody have any clue on how to remove the timer circuit on a remote starter so the car will run indefinately?

Specifically on an Auto/Polarstart unit?

SQ_Rules 02-28-2006 06:42 PM

Unfortunatly there's no way of doing what you want to do in that case.

Max runtime you can get on an autostart is 30 minutes if you program it to diesel mode

6x9'sRULE! 02-28-2006 06:48 PM

Well, you could get it to latch the ignition and acc on with a little fancy relay wiring.

Then use like the trunk output to kill the latching. (Or a switch in the vehicle, or both)

One downside to this is that if it is "accidently" started, you may come back to your vehicle without any gas.

If you need a diagram on a way to accomplish this, let me know

fiero-silva 03-01-2006 11:14 PM

Is it possibly to do on a Compustar unit?

Or anyone know of a unit that I can be done on?

Mizzarty 03-03-2006 12:46 AM

up to 45 minutes on diesel mode in the compustar/firstech products.

soundsgood 03-03-2006 11:05 PM

Dude...
 
Why would you want to keep it on in a permanent fashion? It would not be advised to do so, as your engine won't like it and a huge waste of fuel, if forgotten about.
I'm assuming that you have a good reason for this option, but I doubt that you'll find a starter that'll do this for you.

Starterwiz 03-04-2006 02:12 AM

You can do it, but you'll have to build outboard latching relays for all the circuits that you want to stay on, and use the outputs from the starter to trigger those relays.
Use the trunk output to break the ignition, to reset all your relays, and you're good to go.

Had to do this for remote start on generators.
PM me if you can't figure it out, with the details and I'll put a schematic together for you.

ShonBesharah 03-04-2006 02:38 PM

wait till you see charlies diagrams,they look like road maps of manhatten during rush hour,and dont get him started on kaos theories

BMoney 03-04-2006 09:47 PM

I immediately thought of using latched relays on the required outputs to keep the vehicle running (ignitions, heater, etc). Using the trunk release to break the relays is a great idea :)

Although I'm not sure there is enuf money out there to convince me to do this install - I can just see it now - "my car overheated cause it ran in my driveway for 9 hours before running out of gas and burning up my fuel pump - here's the repair bill mister installer". ;)

bmoney

Starterwiz 03-05-2006 08:33 AM

I haven't used crayons for over a year now Shon :cheeky4:

I wouldn't do that install in a car either. Why would anyone need it?


All times are GMT -5. The time now is 01:43 AM.


© 2024 MH Sub I, LLC dba Internet Brands