I got a 2000 accord coupe and im looking for the best method of running wire from the mids in the door to the inside and then on back to the cross overs......

[ September 19, 2004, 09:22 PM: Message edited by: CasinoGreek ]

 

maybe this thread might help?

http://www.canadiancaraudio.com/cgi/...;f=10;t=001386

 

Great thread to post MikeMac; I had forgot about that one.

So are we pretty sure that 2000 Accord coupe has a molex on the door side? Undo it from inside the door?

 

200 Accord?? I dont think it has a molex plug????
I'm actually 99.9% sure it doesn't

 

well i looked at my door and from the outside it looks like the the first picture in the molex thread, i guess i wont find out for sure untill i open the door and take a good look....thanks for posting that thread though , ill know exactly what to do should i run into that problem.

 

You won't know for sure until you actually get in there and start doing the work. My car doors looked like the first pic too, but I was lucky enough to find that it was just a wire housing with no plugs on either end (But a narrow one that was still tight to run 2 more wires through).

 

for those of you familiar with Honda molex's, is it possible to run two pairs of speaker wire through them? what is the largest gauge?

car is a '95 Integra btw, hoping to mount the x-over outside of the door

 

^did you check out the link MikeMac provided?? It had pics of an Integra. I mean, what more do you need?
Two 16awg sure looks do-able.