I am running a stinger 0 gauge wiring kit in my 1996 golf. It comes with a beefy fuse holder, the pro-style anl type. I will take a picture of my engine bay, but I have no idea where the hell to put this thing. Any ideas would be great. I got my new deck in and sub finally in the box and wired up, just need to get my amp setup.

 

less then 18" form the battery is where the fuse needs to be and befor it goes though the firewall

 

I know that part, I'm just asking where in the engine bay I can find room/mount this beast. I think pictures will help my question.

 

ya I just used some tie downs and tied it up to what ever was close to it haha.
it is pretty secure and doesnt move.

 

how about a couple dabs of silicone to the bottom and put it on the batt?

 

That might work. I would just use wire ties, but the thing is pretty heavy. Pictures will be up after work.

 

I got some really heavy duty outdoor double sided sticky tape, RHDODSST at canadian tire?
Or you could use cable ties. I cable tied mine to a support bracket that goes over the battery.
In my last car, I drilled and screwed it into the inner fender.

 

I had a hard time finding space for mine too. I made a plate that attaches to the top of the battery:

 

I have put an L bracket in, anchored it to the sheet metal

as above my current space is limited (and not enough room for a snazzy vertical install like that) so I drilled a hole in the side of the shock tower and used a piece of sheet metal to mount to not elegant but it works

 

cable ties will work but it won't look quite as clean as securly screwing it on somehwere