Car Audio Forumz - The #1 Car Audio Forum - wiring up a PG QX2180 amp

Car Audio Forumz - The #1 Car Audio Forum (https://www.caraudioforumz.com/)

- Install related (https://www.caraudioforumz.com/install-related-17/)

- - wiring up a PG QX2180 amp (https://www.caraudioforumz.com/install-related-17/wiring-up-pg-qx2180-amp-8473/)

93 HUSTLER

12-29-2003 08:36 PM

I am planning on running two sets of Orion 5.5 inch coaxial speakers and running them off a Phoenix gold QX 2180 amp (2 channel ,50 rms a channel). I'm wondering what the best way of wiring them is so I get the maximum amount of watts without harming my amp. I'm also going to install a US acoustics amp bridged mono 300 watts rms to a kicker 8" comp sub. Do you think my sub is going to overpower the front speakers? I'm sticking all this into a 93 nissan regular cab truck. Any advice would be greatly appreciated.

Hardwrkr

12-29-2003 09:07 PM

Wire up the QX in 2ohm stereo (2 speakers per side).
The sub will match fine with proper gain and crossover settings.

93 HUSTLER

12-30-2003 08:25 PM

Speaking of crossover frequency, I'm wondering where I should crossover my 8" at. I listen to mostly hip hop, electronic, and punk.

2 8's AKA Jeepbeats

12-31-2003 09:55 AM

Quote:

Originally posted by 93 HUSTLER:
Speaking of crossover frequency, I'm wondering where I should crossover my 8" at. I listen to mostly hip hop, electronic, and punk.

Probably around 80hz should be fine. Just listen to your music through it, and tweak it until it sounds right.

hanibal

06-04-2009 06:37 AM

Will this amp run Pheonix Goldrsd65cs components good?

All times are GMT -5. The time now is 03:59 AM.