new box deisgn
new box deisgn
anyone wanna help with some new box designs for a 12" type R. my current box sits in back seat, ***** hard as but want it in the trunk now and it doesnt fit ill give dimensions if anyone is interested
different box, diff tuning maybe? and with round ports instead uhm height is 14 to 15
and width about 40 inches depth wont really matter. but i kinda wanna cut out a view panel in the back to see the back of the mag. and light er up so ill take that into account later. and if you make it shorter than 40 inches porting could be out the side but if not it would have to be on the front or back. thx
and width about 40 inches depth wont really matter. but i kinda wanna cut out a view panel in the back to see the back of the mag. and light er up so ill take that into account later. and if you make it shorter than 40 inches porting could be out the side but if not it would have to be on the front or back. thx
thanks jalat i was going more for a tube port instead i got another design from someone and then yours so i have 2, plus one i just did on the re site.
the other guys box was this.
the bottom and top 30x13
Front baffle and back 30x13.5
sides 11.5dx13.5 tall
port lengths will be 18.67 inches and will come out to 2.386 ft^3
port diameter is 4"
what would be a better box? ive never done a tube port so i kinda wanna do one, and im not sure the tuning of the box, i tried on boxbuilder 6 and couldnt figure it out
the other guys box was this.
the bottom and top 30x13
Front baffle and back 30x13.5
sides 11.5dx13.5 tall
port lengths will be 18.67 inches and will come out to 2.386 ft^3
port diameter is 4"
what would be a better box? ive never done a tube port so i kinda wanna do one, and im not sure the tuning of the box, i tried on boxbuilder 6 and couldnt figure it out
i personally would rather have a slot port enclosure than an aeroport enclosure. REAL aeroports just cost too much and sometimes give off some dirty port noise.
you also said you dont know what the tuning of the enclosure is.... that wouldnt be all to wise to use especially not knowing what you're gonna expect.
i would use my blueprint cause its easy to build, and will give great results for your application
you also said you dont know what the tuning of the enclosure is.... that wouldnt be all to wise to use especially not knowing what you're gonna expect.
i would use my blueprint cause its easy to build, and will give great results for your application
