Condition: Used
Category: Amps

I have a JL Audio 1000/1 / 450/4 for sale.

Power Type: D class


Asking Price is $ 600


Hey guys i'm selling my 2 amps that came out of my truck.
They are in great working shape one amp as you can see from the picture has a little bit of damage.
The damage is only cosmedic.
I payed $1300 just 2 years ago
I'm in Mississauga*

Asking price $600 OBO
**

1 pair of Differential-Balanced Inputs
*** Fully variable on-board crossover: (40Hz - 200Hz), selectable-slope LP (12 or 24 dB per octave)
*** 2-channel Preamp Outputs: independent active filter, parallel with amp filter or full-range
*** Bass EQ that is parametric with variable bass boost up to 15dB and you can use a Remote Bass Control (optional RBC-1)*
*** Fully variable Infrasonic Filter: 24dB/octave from 15-60Hz
*** Output Polarity Reversal switch allows instant output polarity reversal
*** Dual mono speaker output connections that accepts up to 8 gauge wire
*** 12 volt and Ground connections accept 4 gauge wire or 2 gauge or 1/0 gauge

Specifications:

*** Rated Power: 1000 watts RMS at 1.5 ohm - 4 ohms (at 11V-14.5V)
*** THD at RMS Power: <0.05% @ 4 ohm
*** S/N Ratio: >95dB below rated power
*** Frequency Response: 5Hz - 500 Hz
*** Damping Factor: >500 at 4 ohms /50Hz
*** Input Range switchable from 200mV-2V RMS
*** to 800mV-8V RMS
*** Dimensions: 19.7"L x 9.25"W x 2.36"H

Features & Specs

Power Specifications - Full Range Channels
RMS Power @ 4 ohms*** 1000 watts x 1 channel
RMS Power @ 2 ohms*** 1000 watts x 1 channel
RMS Power @ 1 ohm*** (at 1.5 ohms) 1000 watts x 1 channel
Bridged RMS Power*** N/A
Peak Power Output*** N/A
Amplifier Specifications
Amplifier Class*** D
Number of Channels*** 1 - Mono
Total RMS Power Output*** 1000 watts
Minimum Impedance Unbridged*** 1.5 ohms
Minimum Impedance Bridged*** N/A
THD at Rated RMS Power*** 0.05%
Speaker Level Inputs*** No
Preamp Outputs*** 1 pair
Built-in Crossover*** Low-pass (LP)
High-pass (HP)
High-Pass Crossover Frequency*** 40 - 200 Hz
Low-Pass Crossover Frequency*** 40 - 200 Hz
Subsonic Filter*** N/A
Signal-to-Noise Ratio*** 95 dB
Channel Separation*** N/A
Bass Boost*** 0 - 15 dB
Bass/Gain Remote*** Optional (Accessory required and sold separately)

*** JL Audio RBC-1

Fan Cooled*** No
Fuse Rating*** 100AA x 1


Specifications:

*** Channels 1 and 2:
******* Rated Power (stereo mode): 150W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)
******* Rated Power (bridged mode): 300W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V)
*** Channels 3 and 4:
******* Rated Power (stereo mode): 75W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V)
******* Rated Power (bridged mode): 150W RMS x 1 @ 3 ohm-8 ohm (11V-14.5V)
*** THD at Rated Power: <0.03% @ 4 ohm
*** S/N Ratio*: >108.5 dB below rated power
*** Frequency Response: 5 Hz-30 KHz (+0, -1dB)
*** Damping Factor: >200 @ 4 ohm per ch./50 Hz
*** Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS
*** Dimensions: 13.4"L x 9.25"W x 2.36"H

Features:

*** Differential-Balanced Input Topology: (2 pairs of inputs)
*** Channels 1 and 2 Crossover:
******* Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave)
*** Channels 3 and 4 Crossover:
******* Fully-variable (50 Hz-5 KHz), selectable-slope LP or HP (12 or 24 dB per octave)
*** Preamp Output: 2-channel (Pass-through with selectable input sourcing)
*** Bass EQ: +6 dB (variable boost up to +15 dB with Remote Bass Option)
*** Infrasonic Filter (Channels 1&2 only): defeatable 24dB/octave at 30 Hz
*** Speaker output connections: accept up to 8ga. wire
*** +12V and Ground connections: accept up to 4ga. Wire



Features & Specs

Power Specifications - Full Range Channels
RMS Power @ 4 ohms*** Ch. 1&2: 150W x 2; Ch 3&4: 75W x 2
RMS Power @ 2 ohms*** Ch. 1&2: 150W x 2; Ch 3&4: 75W x 2
RMS Power @ 1 ohm*** (at 1.5 ohms) Ch. 1&2: 150W x 2; Ch 3&4: 75W x 2
Bridged RMS Power*** Ch. 1&2: 300W x 1; Ch 3&4: 150W x 1
Peak Power Output*** N/A
Amplifier Specifications
Amplifier Class*** AB
Number of Channels*** 4
Minimum Impedance Unbridged*** 1.5 ohms
Minimum Impedance Bridged*** 1.5 ohms
THD at Rated RMS Power*** 0.03%
Speaker Level Inputs*** No
Preamp Outputs*** 1 pair
Built-in Crossover*** Low-pass (LP)
High-pass (HP)
High-Pass Crossover Frequency*** 50 - 500 Hz
Low-Pass Crossover Frequency*** 50 - 500 Hz
Subsonic Filter*** N/A
Signal-to-Noise Ratio*** 108.5 dB
Channel Separation*** N/A
Bass Boost*** Bass EQ (on/off)
Bass/Gain Remote*** Optional (Accessory required and sold separately)

*** JL Audio RBC-1

Fan Cooled*** No
Fuse Rating*** 60A x 1**

 

pitures would be nice.. also its supposed to be a rule on here..

 

Here are some pics for the ones that have asked.

 

the 450/4 has been SOLD

Price on the 1000/1 is $ 350 Firm
pick up location is in Mississauga

 

do u still have the 1000jl