cant wait.

 

LOL bring it on FATHER LOL
LOL I h8 to agree with you about something LOL, doesn't allow for me to stir with you

 

I think bending the wood is by setting just the right height of the blade on a table saw so that it wont cut thru the wood (just barely depending on wood thickness) then space them out evenly per cut. Voila, bendable mdf. Check his pics again, you'll see it.

Sick box tho!

 

i had it at 1/4" in between and 1/8" left to play with and i still had to put boiling water on it or it just broke hopefully my next box goes better lol

 

your not going through far enough then, I've been doing this to MDF for years. It works well, but you need to make sure you cut enough material. The size of the Kerf cut will tell you what max/min raduis you can use.

 

thx ill try again next time i make a new box lol still came out nice tho you can see the pics http://www.canadiancaraudio.com/onli...5098-done.html

right there

 

Kering just takes patience..I have even done it with Hardwood

 

nice box

 

I have also chimed in on the gloss paint

If you do a box with large flat areas a wood venier would be cool too

 

kerfing and aint hard but ya as you said trevor takes patients.... I had it easy when workin in vernon I ran a cnc router I could make it do kerfs for me and hole cut outs etc.... however I normally did that myself by hand...