I didn't put in the mounting hole. It has to be 11" for the sub. I was hoping to have it equal distance between the bottom, right side, and lower-right corner of the port opening.

The red lines indicate where I'd like rounded corners. Should have added that to the bottom of the port, as well.



That's what I'm after. I was hoping someone with a proper design program can mock one up so I can see what it will look like.

I figure it'd take about a 4'x4' (half sheet) of 3/4" MDF, $5 in screws, and a couple bucks in glue. $30 in material, lets say. If I can get it built for $80-$100, that'd be nice.

Where's JoeF these days?

 

you have PM

 

I'm around, just a little busy with xmas. PM me at your convenience