cadence ultradrive x 2 enclosure help
 

hey i'm looking for some help designing a ported enclosure for two cadence ultradrive z10w-2 subs.. these will be going into the back of a 1991 ford escort and yes i will be building the enclosure myself.. there are two of these subs for $50 each at a local pawn shop up here so i'm gonna go snatch em up and give em a try next pay day.. i'm also going to be needing an amp for these so i was probably just going to be picking out an amp once i can get a better look at em possibly tomorrow..

alright so heres the specs on these subs..

Size - 10"
Voice Coil - 2" Four-Layer
Impedance - 2Ohm Single Coil
Power Handling - 300 Watts RMS/ 600 Peak
Long Life Power - 250 Watts
Frequency Resp - 30Hz - 2Khz
Magnet Size - 100 oz. structure
SPL @ 1W/1M 93dB
Mounting Depth - 5.5"

TS PARAMETERS

Z=31.79
Fs=31.32
Pe=300
SPL=85
Re=2
Le=2.11
BL=8.26
Xmax=0.0085
Cms=0
Qms=9.575
Qes=0.6427
Qts=0.6013
Sd=3.6E-6
Vas=42.5339
Type=0

i was thinking a 500W amp would do the trick for these quite nicely.. and as for an enclosure im just lookin for a little assistance on that.. i'll be able to get measurements of my trunk tomorrow and i'm not lookin to cut it to bits in there.. just need a box to set inside.. if possible i'd like to keep as much trunk space as i can because i have no idea if i'm going to need it.. or if i'm going to need access to my spare tire.. happens eh.. lol

anyways.. any help would be greatly appreciated :) thanks :)