Hi there!
I am looking for someone who can fabricate for me a custom fiberglass enclosure for my Forester.
Interested in a single enclosure (one 10" sub) in similar fashion to what was done in link below.

http://www.subaruforester.org/vbulle...losures-63837/

Please PM me to discuss

Thanks
Renato

 

Davis @ Selective did a good job on mine.

 

yeah Davis
not sure if he will take on another custom project right now. he has had my truck for almost 2months and its not even close to being done yet.
well minus the 4 days i took it back for a planed trip to montreal.
although u might be better off at this time because his primary custom guy (max) is back in the shop full time next week (off for the summer from school)
i do hope he gets my truck done and soon, im starting to get antsy

good luck

Dan

 

im sure someone on the forum here could do it if you purchase the materials needed and paid them the labour. Id do it for much less than a typical install shop which will cost you around 60+an hour for labour. takes a bit of time and fitting to cure properly. also how do you want to finish it? vinyl? paint? whats your budget?