New Box
#12
It wont hurt your subs but it you will loose bass in certain frequencys, check this site out: http://www.diysubwoofers.org/faq.htm this will explain it for you, you should build the box to what the manufacture suggests.
#16
Originally Posted by storky45
ya i have been using it and it came out with 7cubic feet to tune it to 35hz so the box's demensions would have to be 37.5X 15X 26 inches
Tried it in a couple of different box programs and the verdict seems to be to stay sealed. That figure of 2.394cuft is the VAS of the driver, not a recommended enclosure size. The peak in the response curve for the sealed box at 1 to 2 cuft/sub is bigger than some I've seen in ported models for other subs. In the interest of keeping it listenable (and having it fit in something smaller than my van..... ) I would stick to a sealed 6cuft box. The curve is still there, but it's a lot flatter than the smaller box, and the -3db down point of 28hz is very low.
It sounds like you have lots of space in the trunk, so.....36"w X 14"h X 22"d gets you close and a couple of braces to stop any panel flex will fill in the rest.
Watch your power, with that much air behind them it will be relatively easy to over-drive the subs.
Let us know what you decide to do, I'm curious to hear what your results are like......nothing like cutting up some MDF for an over-the-top box for some off-brand subs......
HTH
#18
Well i finally got time to work on my box and an amp rack so here are the pics. I shortened the box so it would fit better. and made the amp rack so i could get the spare out if i need to. I still need to put the bamboo on the front and hook everything up + i want to put a light behind the amp and on shining onto the front of it im thinking red. I already have blue ones on the inside.
#19
Does ne one have ne ideas for lighting? i want a different color than blue since i have blue on the inside of my box. I was thinking red. and then when i get another amp for the other side i was thinking green for it.Ne Suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
alexdbest2000
General Discussion
3
08-26-2007 10:37 PM
cav2nv420
Enclosure Design & Construction Help
5
03-12-2007 09:21 PM
TravisB
Enclosure Design & Construction Help
0
09-26-2006 10:32 AM