amp and sub question....
ok im new to this kind of thing. ive never done this b4 so i need an answer plz.
ok im getting these 2 12" pioneer 800 watt subs and a 800 watt 2 channel amp. here are the specifications. tell me if this would work. AMP: # Channel Amplifier # RMS Power Output: * 125 watts RMS x 2 chan. @ 4 Ohms * 170 watts RMS x 2 chan. @ 2 Ohms * 340 watts RMS x 1 chan. @ 4 ohms # Peak Power: 800 watts, 4-ohm stable bridged # Low-pass crossover: 50-300 Hz, 12 dB/octave # Variable bass boost: 0-10 dB at 40 Hz # MOSFET outputs and power supply # CEA-2006 compliant # Speaker-level inputs with high-level sensing # Preamp inputs and outputs # Dynamic Distortion Suppressor # Fuse Rating: 30A x 2 # 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier # Dimensions: 12-3/4"W x 2-1/4"H x 10-7/8"D # 1 Year Autosounds4less Warranty SUBS: * 12" high powered sub * 800 Watts Maximum Power * 150 RMS Rating * Frequency Response: 20-4000Hz * 91dB Sensitivity * IMPP Composite Cone for strong bass response * Ferrite Magnet * Wide-Roll Dual-Layer Urethane Surrounds eliminates distortion * 4-Layer Voice Coil * Projected Pole Yoke with Vented Pole for even and strong sound * Magnet Cover * Push Terminals * 4 Ohms Impedance remember im gettin two of those subs! ok plzwrite back asap thx alot. |
Wrong amp. When you take two 4 ohms subs in paralel, you get a 2 ohm load.
you need a mono amp, 2 ohm. GM-D7400M 400 x 1 @ 2 ohm |
it could work, just hook up one sub to one channel on the amp. Each sub would be gettin the 125rms @ 4ohm
|
will work fine wired dual 4 ohm will thump a lil not super lowd but will work fine
|
would it still be loud tho like would they hit hard?
|
yes they will not insanly loud but they will thump it wont be long tho before you want more
|
All times are GMT -5. The time now is 10:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands