ok im new to this kind of thing. ive never done this b4 so i need an answer plz.
ok im getting these 2 12" pioneer 800 watt subs and a 800 watt 2 channel amp.
here are the specifications.

tell me if this would work.

AMP:

#
Channel Amplifier
# RMS Power Output:

* 125 watts RMS x 2 chan. @ 4 Ohms
* 170 watts RMS x 2 chan. @ 2 Ohms
* 340 watts RMS x 1 chan. @ 4 ohms

# Peak Power: 800 watts, 4-ohm stable bridged
# Low-pass crossover: 50-300 Hz, 12 dB/octave
# Variable bass boost: 0-10 dB at 40 Hz
# MOSFET outputs and power supply
# CEA-2006 compliant
# Speaker-level inputs with high-level sensing
# Preamp inputs and outputs
# Dynamic Distortion Suppressor
# Fuse Rating: 30A x 2
# 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
# Dimensions: 12-3/4"W x 2-1/4"H x 10-7/8"D
# 1 Year Autosounds4less Warranty

SUBS:

* 12" high powered sub
* 800 Watts Maximum Power
* 150 RMS Rating
* Frequency Response: 20-4000Hz
* 91dB Sensitivity
* IMPP Composite Cone for strong bass response
* Ferrite Magnet
* Wide-Roll Dual-Layer Urethane Surrounds eliminates distortion
* 4-Layer Voice Coil
* Projected Pole Yoke with Vented Pole for even and strong sound
* Magnet Cover
* Push Terminals
* 4 Ohms Impedance


remember im gettin two of those subs!

ok plzwrite back asap thx alot.

 

Wrong amp. When you take two 4 ohms subs in paralel, you get a 2 ohm load.
you need a mono amp, 2 ohm.

GM-D7400M
400 x 1 @ 2 ohm

 

it could work, just hook up one sub to one channel on the amp. Each sub would be gettin the 125rms @ 4ohm

 

will work fine wired dual 4 ohm will thump a lil not super lowd but will work fine

 

would it still be loud tho like would they hit hard?

 

yes they will not insanly loud but they will thump it wont be long tho before you want more