BMF1000D, not reaching potential
#11
Gain is set to minimum and I have been using the PLD1 to adjust the output level. It was initially set up on slave but i have set it to master, 0. Subsonic filter is set to 20hz but it doesn't make a huge difference in output when turned off, and I like to leave it on since it's in a ported box.
I do realize that I am only using half the power (500w) but I think it should still be stronger than what it putting out now. I was only giving it 200w and it was hitting lots harder than it is now.
I do realize that I am only using half the power (500w) but I think it should still be stronger than what it putting out now. I was only giving it 200w and it was hitting lots harder than it is now.
#12
Thats funny, i have a BMF as well, hooked up to a Quad coil XXX 15, running at 1 ohm, and it moves the sub damn well......4g wire, and an 105 amp alternator and stock battery....80 amp fuse too.....kinda odd, my speaker moves like crazy
dc
dc
Thread
Thread Starter
Forum
Replies
Last Post
Soundigital
General Discussion
4
12-20-2008 03:59 PM
alpine-F1
Canadian General Car Audio Discussion
0
02-10-2005 10:52 AM