I have a 05 Chevy Colorado LS Crew cab, there are stock components in the front doors. I am wondering if there is already a crossover in there that i can switch with the new one, or do i have to find a spot that it will fit?

 

No stock crossover. The tweeter may have a tiny cap attached to it.

 

ok, thank you... now i gotta figure out where and how to mount it.

 

there should be some room on the back side of the door panel. Or on the inside of the door.

 

perfect... ty... i will be installing the speakers tomorrow afternoon.

 

i would always suggest to run new wires into your door and to your tweeter and mount the x-over inside the vehicle, doors are not very sealed so there can be a lot of moisture in there. you wouldn't believe the amount of beat up x-overs i have ripped out through the years,

 

yea, thanks for the info, greatly appreciated, i have put the crossover inside the doorpanel compartment, and have run new stinger wires from the crossover. To the crossover are the stock wires, but gunna upgrade to stinger after I install an amp. Now I am looking for a headunit, right now the top choice is the Alpine INA-W900BT.

 

Save up a bit more money and get a Ina-w910, its a way better deck for the couple hundred it cost to upgrade