Rob

iTrader: (2)

Hey there,
I have the UP5 Components up front.
I opened the DLS passive x-overs..
Inside there is a pin..
On 1 side you can adjust the tweeter level (High or low) and the other side you can adjust the tweeter x-over (low,med., high)

What is this for ?
What should I have it set at ?
I played around with it, but I don't hear a noticeable difference..

PS: My amp is crossed over at 90hz. Is that okay ?

pic:
look at the bottom, insideof the x-over
http://dls.se/images/highres/UP5_F.jpg

[ March 28, 2004, 09:53 PM: Message edited by: Rob ]

TomK

Jumper 1 (J1) is in the "IN" position when tweeter is mounted away from the mid and it's in the "OUT" position when the mid and tweeter are mounted together. The high/med/low is the tweeter level output.

Who's doing you installation of these components ?!?!? Pretty sure all this information is right in the included user manual that comes with the set. It's also on the DLS web page as a PDF file.

--------------- DLS Web Page Link ----------

[ March 29, 2004, 07:49 AM: Message edited by: dawgsbreakfast ]

Rob

iTrader: (2)

On the J1, it just says high or low...It doesnt say "in" or "out"
which is high and which is low ?

thanks

[ March 29, 2004, 10:46 AM: Message edited by: Rob ]

TomK

Hi = In from what I understand

cdj

Rob,

You can contact:

SCOTT BUWALDA expert240sx@msn.com

he uses the DLS's in competition and is a dealer.
Very pleasant and helpful person who is active on a couple of boards.

[img]smile.gif[/img]

Rob

iTrader: (2)

THANKS