Wondering what a good amp would be to run 2 x 13w7's?
Any suggestions?

 

MTX 81001. The one I just unpacked is rated for 1968 watts rms into a 1 ohm load. A pair of your W7's wired in a series parallel arrangement will yield a 1.5 ohm load. This is more than adequate power for a pair of those drivers.

 

T3 1000D. lots of power, and smartass has em cheap right now. you wont find an amp that puts out more power for only 400 bucks.

 

Zapco C2K 9.0 (two of them of course)

 

think the 13w7 could handle running one of these amps each. Or would i write-off a 13w7 With that much power
http://www.mtx.com/caraudio/products/amplifiers/thunder81001.cfm

 

If you have the subs wired in series, it would be right in the proper region for the amount of power to take it to the max. One amp could indeed do the job properly but if you want two amps, then go for it.