Hey guys. I've just gotten myself a set of JBL GTO's (GTO527) and was just wondering how I wire them into my 4ch to run at their advertised 2 ohms.

 

If they are dvc just bridge the channels together i believe and by having 2 subs it will go into 2 ohms but i am not sure since I have never had dvc subs.

 

they are what they are, a 2 or a 4 ohm load. the amp is what takes different load's so does you amp like 2 ohm's stereo?
how many subs do you have?
do they have 2 coils or one?
and whats your amp?

 

They are a single coil 2 ohm speaker,,, run them directly positive and negative to the channels on your amp. the idea of these speakers being 2ohm is to create a consistant load on your amplifier through all frequences when most 4 ohm speakers fluctuate from 4 ohms to what ever.

James

 

If you're looking for a 2 channel amp to pound those subs feast your eyes on this big boy. PM me for a price. It was amp clamped @750 per side. It will run @2 or 4ohms

 

where are these dragster amps from and sold? i have only seen these amps once and it was in a car done *supposedly* at one of the west coast shops, it was the most ridiculous install jobs ive seen by a prossesional shop very scary, anyways the amp didnt sound too bad...didnt get much of a listen however, was too busy re-wiring, the cat 5 or coax cable they used as speaker wire

 

Has anyone not noticed these are not subs? But they are 5.25" Will will most lkely only be able to use two of the four channels one on each and it will load those two channels into 2 ohms

 

lol..^ that is truly funny. 5.25" and not a sub! I thought for sure it was a sub by reading it

 

I guess everyone just likes bass

 

Haha true enough!