Memphis amp question
#1
This may be a really dumb question but I'll blame it on somebody else putting the idea into my head. My Memphis ST1000D is a mono amp. Does it have to be wired any fancy way on the dual blocks to get the right amount of output (bridged so to speak) or is all that is required just hooking up positive's and negative's on the block.
#2
It's only a one channel amplifier so it dosen't matter if you wire it to the left or right input, or "bridge" the two. You will still only have a one channel amp. No increase or decrease.
Thread
Thread Starter
Forum
Replies
Last Post