Newbee need help bad
#1
Newbee need help bad
Hello I just bought 2 12" pioneer ts-w306c subs they are 4ohm subs they are 1000w max each and 400w nominal. I need to figure out what mono amp to power them any ideas thinking I need a amp of at least 800rms. also is it possible to make them into 2ohm subs even know they are not dvc.
thanx
bradross@nb.sympatico.ca
thanx
bradross@nb.sympatico.ca
#2
Originally Posted by fubar
Hello I just bought 2 12" pioneer ts-w306c subs they are 4ohm subs they are 1000w max each and 400w nominal. I need to figure out what mono amp to power them any ideas thinking I need a amp of at least 800rms. also is it possible to make them into 2ohm subs even know they are not dvc.
thanx
bradross@nb.sympatico.ca
thanx
bradross@nb.sympatico.ca
regards, Mark
#6
you could probably find a good used one..look around...rockford is also good...i like the older models..probably if you could get your hands on a BD1000..its a nice amp..maximum@ 2ohms i think...it would be gr8 for your application...
Thread
Thread Starter
Forum
Replies
Last Post